Lens redesign

Troubleshooting and optimisation

Projection lens. Redesign of the mechanical components to achieve the specification.

Initial situation

Why is the lens not working even though all parts were manufactured correctly? Are there any potential improvements? Can the manufacturing cost be reduced? Are there any fundamental faults in the system? Is optimisation possible?

CEMEC Services

Basic fault analysis and analysis of the design concept. Consulting on potential design improvements. Manufacturing consulting. Optimisation of the manufacturing process. Consulting for testing processes. Improvement recommendations.

Result

Determination of the system error and simplification of the design with more cost-effective production at the same time.

The changes achieved the required technical data, significantly reduced the total cost.

Customer

In-Vision, Vienna

This website is using cookies

These include essential cookies that are necessary for the operation of the site, as well as others that are used only for anonymous statistical purposes. You can decide for yourself which categories you wish to allow. Please note that not all functions of the website may be available due to your settings. You can adjust your preferences at any time under privacy policy.

This website is using cookies

These include essential cookies that are necessary for the operation of the site, as well as others that are used only for anonymous statistical purposes. You can decide for yourself which categories you wish to allow. Please note that not all functions of the website may be available due to your settings. You can adjust your preferences at any time under privacy policy.

Your cookie preferences have been saved.